Social Media


Welcome, Guest
Username Password: Remember me

Cage additional mounting points vague?!?!
(1 viewing) (1) Guest
  • Page:
  • 1
  • 2

TOPIC: Cage additional mounting points vague?!?!

Re: Cage additional mounting points vague?!? 11 years, 1 month ago #15325

  • joeblow
  • OFFLINE
  • Seasoned Racer
  • Old Racer
  • Posts: 226
OK so a single plate from the top of the 'A' pillar to the bottom of the same 'A' pillar is one point even though it is say 30"s long. Then the other point would be the length of the 'B' pillar as well.

Correct?
Old Racer!

Re: Cage additional mounting points vague?!? 11 years, 1 month ago #15326

Yes, that is what we had in mind. Just keep it on one straight piece of tubing.
Eric Kuhns

National Director Emeritus

2007, & 2008 National Champion
2011, 2012 2nd

Re: Cage additional mounting points vague?!? 11 years, 1 month ago #15327

  • joeblow
  • OFFLINE
  • Seasoned Racer
  • Old Racer
  • Posts: 226
Well in my scenario I am talking a long piece of sheet metal with dimpled holes bridging the gap between the roll cage and the 'A' pillar starting at the top of the windshield area down to the dash. The plate will be between 1" and 2" wide to fill the gap.

I will post a picture...
Old Racer!
Last Edit: 11 years, 1 month ago by joeblow.

Re: Cage additional mounting points vague?!?! 11 years, 1 month ago #15328

  • joeblow
  • OFFLINE
  • Seasoned Racer
  • Old Racer
  • Posts: 226
dscf0006.jpg



Like these on the A/B pillars
Old Racer!

Re: Cage additional mounting points vague?!?! 11 years, 1 month ago #15333

That's fine.
Eric Kuhns

National Director Emeritus

2007, & 2008 National Champion
2011, 2012 2nd
  • Page:
  • 1
  • 2
Moderators: joepaluch, tcomeau, KLR
Banner
Time to create page: 0.08 seconds