Camshaft wear

Social Media

TOPIC: Camshaft wear

Camshaft wear 7 years, 11 months ago #21458

Manuel_M OFFLINE Junior Racer Posts: 65	All the cams I've seen look like this. During a rebuild does anyone buy a new one or regrind to spec? Attachments: pic09.jpg (66KB)
	Reply Quote

Re: Camshaft wear 7 years, 11 months ago #21459

cbuzzetti
OFFLINE
Endurance Racer
944 Spec = The best racing on the planet
Posts: 1192

I am not sure I would use that one. I have never had to replace a cam shaft in a Spec car, so can't tell you much about it.

2018 NASA 944Spec National Champ
2018 NASA ST5 P2 944 Nationals COTA
2017 NASA 944Spec WSC P3
2016 NASA PTD-944 WSC P2
2015 NASA GTS1 Western Champion
2014 NASA 944Spec Western Champion
2013 NASA 944Spec So-Cal Regional Champion
2013 NASA 944Spec National P3
2010 NASA GTS-1 National Champion
2010 NASA 944Spec National P3
2010 NASA So-Cal 944Spec Regional Champion
2009 NASA 944Spec National Champion

Reply Quote

Re: Camshaft wear 7 years, 11 months ago #21460

Manuel_M OFFLINE Junior Racer Posts: 65	This is just a stock photo from pelican, however I've seen maybe 6 and they all were the same. All used ebay ones seem to be the same also.
	Reply Quote

Re: Camshaft wear 7 years, 11 months ago #21473

Robbie OFFLINE Junior Racer The dread pirate Posts: 51	Every cam I've had looks like that too. Never checked the sizes, though.
	1987 924S #5 NASA RM Reply Quote

Re: Camshaft wear 7 years, 11 months ago #21474

Manuel_M OFFLINE Junior Racer Posts: 65	I've read somewhere "on the internet" that it is like that by design to help spin the lifter. Not sure if there is any truth to it, but the top of the lobes seem to not have wear.
	Reply Quote

Reply Topic

New Topic

Page:
1

944-SPEC

Racing Discussion

Race Car Build

Moderators: joepaluch, tcomeau, KLR

Time to create page: 0.08 seconds