Social Media

Welcome, Guest
Username Password: Remember me

Alu to Steel Control Arm Conversion
(1 viewing) (1) Guest
  • Page:
  • 1

TOPIC: Alu to Steel Control Arm Conversion

Alu to Steel Control Arm Conversion 2 years, 4 months ago #22294

Hey everybody. As you may have seen my thread down below, I've been slowly building a 944 Spec racer while in University the last few years (And I do mean SLOWLY.

I'm at the point of converting the front suspension from Aluminum to Steel control arms for the extra strength and reduced cost, and was wondering if anybody had a complete list of Hardware which is required for the conversion? I have the Arms, Ball joints, Bushings etc. But the actual fasteners that came off the car when it had the OEM Aluminum arms are all rusted and useless.

Do I need Early Offset steel arm hardware to fit the Steel arms to my 86.5 previously aluminum armed car? If so where can I get a complete package of all the hardware? (A-arm to Chassis Fore and Aft, Ball joint to shock tower etc etc)

Sorry for the potentially idiotic question, I'm really close and just need to clear the last few hurdles before she finally drives again! Hope you're all staying safe and have had tons of time to work on your builds.
  • Page:
  • 1
Moderators: joepaluch, tcomeau, KLR
Time to create page: 0.06 seconds